VBrick Systems VB Directory System Bedienungsanleitung PDF herunterladen (Seite 5)

STB v3.7.3b Quick Start Guide

STB Quick Start Guide 3

present. If a DHCP server is not available, you can configure the set top box with a static IP

address. The STB is set to a default IP address of 172.17.11.111 as a convenience. In most

cases, this should be changed to avoid conflicts. You can find this IP address using a

keyboard connected to the PS/2 port or by using a terminal connected to the serial port as

explained below.

T To determine the STB IP address:

1. If a DHCP server is present, go to Finding the DHCP IP Address

to determine the IP

address of your STB in DHCP mode.

2. If a DHCP server is not present, go to Assigning a Static IP Address

to manually assign an

IP address other than the default.

Finding the DHCP IP Address

T To determine the IP address of the set top box when configured using DHCP:

1. Connect a keyboard and TV monitor to the set top box and apply power. (Use the

optional wireless keyboard or a PS/2 keyboard). Wait for the box to completely power up

before continuing.

2. Press Ctrl-Alt-F1 on the keyboard to open a Command Prompt window.

3. Login using

root and admin for User name and Password. (To change the password, go

to the Configuration: General > Security page in IWS.)

4. At the prompt type

ifconfig and press Enter. This shows the IP address, the network

interface configuration, and other parameters.

5. Reboot by powering the STB on and off using

Power push button on front of unit.

Assigning a Static IP Address

T To assign a static IP address using a Command Prompt window:

1. Connect a keyboard and TV monitor to the set top box and apply power. (Use the

optional wireless keyboard or a PS/2 keyboard). Wait for the box to completely power up

before continuing.

2. Press

Ctrl-Alt-F1 to open a Command Prompt window.

3. Login using

root and admin for User name and Password. (To change the password, go

to the Configuration: General > Security page in IWS.)

4. To enter the setup program, type

pman and press Enter.

5. Select

Parameters (using the arrow keys and Enter).

6. Select

Network > Ethernet.

7. Change

DHCP Enable to Static

8. When prompted, enter the default (case sensitive) user name and password: root and

admin.

9. Click

Enter to reach OK and then click Enter.

10. Change

DNS via DHCP to No.

11. Select IP address using the down arrow and the

Enter key. Using the keyboard, enter the

IP address obtained from your network administrator and press

Enter.

Note By default, DHCP is used to retrieve a dynamic IP address for the STB. If you are not

using a DHCP server, you must configure the STB to use a static IP address. The

default static address is

172.17.11.111.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

VBrick Systems VB Directory System Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung VBrick Systems VB Directory System